New Folding Project Hinge.
Gecko drivers complete kit works fine, except of an abnormal overheating of the Y -
Axis motor (the problem is not with the motor or the drivers). A new
problem came up...PC "freezes" after a few minutes of mach 3 use. Tomorrow
I'll change the PC with a new one to check the abnormal heating.
Trial and error, experimental method of problem
solving, repair, tuning,
or obtaining knowledge.
"Learning doesn't happen from failure
itself but rather from analyzing the failure, making a change, and then trying
again (Coding Horror: Fail Early, Fail Often)
Faulty parallel port (driver) might be the reason of
overheating.
